I am trying to configure a multlink interface on a catalyst 4006 access gateway module. We have two controller ports, one for each of our T1s. Each T1 by itself works fine when it is not joined in the multilink, but when we put both T1s in the multilink the response times are very slow. Any ideas? I know this isnt a router question but the voice module in the switch actually uses the router IOS.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
4006 voice gateway module
- Thread starter ttnnee
- Start date