4.0 BCM 400 SIP registration issue to NRS

[gv82]

I am trying to get a BCM 400 to register via SIP to NRS. The IP address of the BCM does not show up on NRS (Configuration > Gateway Endpoints), which leads me to believe registration is failing.

I'm following Nortel Document NN49000-306. Leaves quite a bit to ones imagination...

Key info:
BCM 400 rel 4.0
CS1k rel 4.5
SIP domain for NRS & BCM match
SIP transport (udp) & port (5060) match
BCM SIP Proxy: NRS sig serv TLAN IP (I've also tried node IP)
BCM SIP URI MAP: matches map used on CS1k which has registered to NRS successfully
NRS gateway endpoint: BCM configured as "dynamic SIP" & No Authentication

Does NRS offer a CLI? The GUI gives little (if any) troubleshooting information.

If anyone can share some ideas or insight I'd be very thankful.

 

[gv82]

I should also point out that the BCM is already registered to NRS via h.323. This is a lab environment, and we'd like to test out both protocols. Any reason the h.323 registration to NRS would prevent SIP from working?

 

[biv343]

Are you statically configuring the endpoint IP and info in the NRS? BCM doesn't support dynamic endpoint registration with SIP, only H.323. I don't know why they chose to go static with the SIP implementation.

Anyways, define a static SIP endpoint in NRS with the BCM information, and enter the SS TLAN IP as a SIP proxy server in the BCM and you should be OK.

 

[gv82]

Thanks biv343. Working like a champ now.