3COM 5500-G VLAN issue

[Matthijs12]

Hi all,

Default all ports are in VLAN1.

I need two ports in VLAN2 communicating in exactly the same way with each other as the other ports in VLAN1 do.

I the following config correct?

interface vlan 2
no ip address

interface GigabitEthernet2/0/24
port access vlan2
port link-type access
stp edged-port enable
duplex auto
speed auto
description

interface GigabitEthernet2/0/28
port access vlan2
port link-type access
stp edged-port enable
duplex auto
speed auto

Best regards
Matthijs

 

[Bas1234]

Give the VLAN 2 an IP adress, delete the two port from VLAN1 and add them in VLAN2 Untagged. It could be that you have to put them in trunk mode.

Greetzzz...Bas

___________________________________________
It works! Now if only I could remember what I did...
___________________________________________