is there anything special I should do to get the 3925 to see the wic 1am installed in slot 0? I put it in there (system was turned off) but after boot, I can't grab that async interface to configure it. It doesn't show up.
with T1 wics you have to issue a card type but I've never had to do that on a plain old modem card..but i've not worked with 3900 series either...
thoughts?
with T1 wics you have to issue a card type but I've never had to do that on a plain old modem card..but i've not worked with 3900 series either...
thoughts?