3845 and NM-T3/E3

[eiregobragh]

Guys,
got a wee issue with a 3845 and an NM-T3/E3 module. I've just taken an old NM-T3/E3 module from an old 3845 and put it into a brand new 3845.

When it comes to configuring the NM-T3/E3 interface I don't get the option for "serial".

Is there any obvious reason for this?

I know the card is being recognised by doing a "sh hardware" and I get the following output:

1 Subrate T3/E3 port

I've even tried running the same IOS as the old router.


Any help is much appreciated,

Paul

Paul Kilcoyne B. Eng.
Innealtóir/ Engineer

http://www.pknetworks.ie

 

[eiregobragh]

Any guesses here lads?

Paul Kilcoyne B. Eng.
Innealtóir/ Engineer

http://www.pknetworks.ie

 

[eiregobragh]

OK I cracked it. You have to tell the router what type of card you have installed:

config: card e3 1

where 1 is the slot I was putting the T3/E3 card into.

Paul

Paul Kilcoyne B. Eng.
Innealtóir/ Engineer

http://www.pknetworks.ie