krazeeddie
Technical User
no c.c's/ uws5a will not load any ideas please. it shows in cp but does not run setup to install on uws5a
the uws's were from 9700 sys if it matters
the uws's were from 9700 sys if it matters
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
3700 3.2sp7hf6
- Thread starter krazeeddie
- Start date
- Status
- Thread starter
- #2
jimmymcp02
IS-IT--Management
I dont think is supported in 3.2 sp7 hf6
see below
POS ApplicationThe Workstation 5A is shipped with an operating system and platform software, but does not contain a POS Application. The MICROS Client Application Loader (CAL) for Windows Embedded CE or CAL 32 for WIN32 clients connect to any MICROS application server and download the application in minutes.Throughout this manual, the term ‘POS Application’ is used somewhat generically, and could in fact apply to any of the following software products listed below. •CAL Server Version V 21 or higher•RES - V4.8•Simphony V1.4 MR5 and V2.1•9700 - V3.6 MR3•e7 - V3.0 MR1
see below
POS ApplicationThe Workstation 5A is shipped with an operating system and platform software, but does not contain a POS Application. The MICROS Client Application Loader (CAL) for Windows Embedded CE or CAL 32 for WIN32 clients connect to any MICROS application server and download the application in minutes.Throughout this manual, the term ‘POS Application’ is used somewhat generically, and could in fact apply to any of the following software products listed below. •CAL Server Version V 21 or higher•RES - V4.8•Simphony V1.4 MR5 and V2.1•9700 - V3.6 MR3•e7 - V3.0 MR1
- Thread starter
- #4
- Status