3640 IOS issue?

[RRTier3]

I was setting up intervlan routing between my 3640 and my 2924, but when i try to set the encapsulation on the sub interface of my 3640 fa port the encapsulation command is not listed. I have ios c3640-i-mz. I read something about the ios needs to include Ip plus which is ios c3640-is.mz. Can anyone verify this for me?

 

[CiscoGuy33]

RRTier3,

Here is a table at Cisco 802.1Q Encapsulation Support
on Cisco 2600 and 3600 Series.

http://www.cisco.com/en/US/products/hw/routers/ps259/prod_bulletin09186a00800921e4.html

Product Bulletin

802.1Q Encapsulation Support
on Cisco 2600 and 3600 Series

Overview
802.1Q encapsulation is now available on the built-in 10BaseT Ethernet interfaces of the Cisco 2610, 2611, and 2612 with Cisco IOS software 12.2(2)T and subsequent releases. Although this feature has been available on the Cisco 2600/3600 series since the release of Cisco IOS 12.1(5)T, support was previously limited to Fast Ethernet interfaces only. 802.1Q is not supported on any other Cisco 2600/3600 series 10BaseT Ethernet interface. Table 1 shows the 2600/3600 series chassis and modules that support 802.1Q:

Table 1 Support for 802.1Q Encapsulation as of Cisco IOS 12.2(2)T

Hope this helps!


E.A. Broda
CCNA, CCDA, CCAI, Network +