3640 Configuration

[DanielBowen]

I have a Cisco 3640 router with two controller E1 interfaces. This is going to be connected to an ISDN 30 line that I have just had installed with a FE interface connected to our internal LAN. Now all we are doing is allowing users to dial in via this router.

What I want to know, is how do I go about configuring the E1 interfaces? I have had a look on the Cisco website but got confused as they started talking about cas-custom commands and ds0 groups.

Can somebody please give me it in basic terminology as to what I would need to do?

Thanks very much

Daniel Bowen,

 

[bobthecat]

Hi Daniel, I recently configured a 3620 with a Pri ISDN using dialer profiles and the description in this link was a realy good help.

http://www.cisco.com/warp/customer/793/access_dial/ddr_dialer_profile.html

The above description only covers Bri's but it is faily straight forward to cover Pri's as well.
Another good souce of configs is

http://www.cisco.com/warp/customer/793/access_dial/3600_index.html

I hope this helps.
Bob ^^

 

[DanielBowen]

Thanks for the info, this is exactly what I would have expected to see. But instead of the BRI or PRI interfaces, I have two controller interfaces instead. Do you know if you configure the controller interfaces the same way?

Daniel,

 

[wybnormal]

The controllers work the same way as any other interface.. just more numbers ;-) You do need to specify line coding,framing, slots and so on.. it's not too hard..

See the following link which should get you going

http://www.cisco.com/univercd/cc/td.../ios121/121cgcr/dialts_c/dtsprt3/dcdchant.htm

MikeS
Find me at

http://www.packetattack.com

"Diplomacy; the art of saying 'nice doggie' till you can find a rock" Wynn Catlin

 

[DanielBowen]

Thanks for your help Bob and Mike, I believe I am now on the right lines

Thanks again,