Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

3512 and ACL

Status
Not open for further replies.
raceman3

raceman3

Technical User
May 14, 2003
27
US
I have a csico 3512 out on the public side of my Internet connection which is what my 3640 router is attached to. I have an ACL in place on the router that only permits Telnet from inside addresses. Is there a way I can do that with the switch as well. I know it is a layer 2 device but I need some way of preventing telnet attachments from the Internet
 
Sort by date Sort by votes
No, the XL's don't support ACL's. Your best bet would be an ACL on the 3640 denying traffic from anywhere outside to switch IP address using port 23.

-Don
 
Upvote 0 Downvote
Actually they do. I didn't even think to look because it is a layer 2 device but when I went into config mode there is an option for access lists. I created one and applied it and seems to work ok
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Lccarter
  • Locked
  • Question
Cisco CUCM Provisioning and Order Management System
Replies
1
Views
136
Lccarter
Lccarter
Mogles49
  • Locked
  • Question
Firewall ACL question
Replies
1
Views
97
burtsbees
burtsbees
acabezas2014
  • Locked
  • Question
Create ACL for ip range
Replies
2
Views
90
acabezas2014
acabezas2014
acabezas2014
  • Locked
  • Question
Need to create QoS for SNMP and Radius traffic on Cisco 4948 Switches
Replies
0
Views
74
acabezas2014
acabezas2014
mrdom
  • Locked
  • Question
RV325: Accessing LAN and WAN resources using the same hostname ...
Replies
0
Views
71
mrdom
mrdom

Part and Inventory Search

Sponsor

Back
Top