3300 controller with Fd pernode attached has a DNI card in 1st slot. The ist circuit has the SC1000 and 15 4025 sets. Console and phones lose sync 5 to 6 times a day for about 20 seconds and restore Have replaced the the MC330 DNI card. No alarms on PBX and syslog says 8 1 1 1 removed due to loss of sync. The DNI and ONS cards in slots 2 thru 10 are not affected only the DNI card in slot 1. Has anyone ever experienced this before. Maybe the power supply but I would think all the cards would then be affected. Maybe the SC1000 or bad phone attached to the card? the log always only shows that 1st circuit has loss sync
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
3300 rls 6 with fd per node
- Thread starter shared1
- Start date
There is a very old issue with DNIC console and keysets going back to the 2K. Reduce the number of buttons supported by the 1st line card. For instance, move the console to a DNIC card with no other sets on it or move some of the keysets off of the 1st DNIC.
NO GOOD DEED GOES UNPUNISHED!
NO GOOD DEED GOES UNPUNISHED!
Yup, what he said
I wouldn't call it an issue. More a design consideration, console does not coexist well with multibutton sets
Too much traffic for the card
**********************************************
What's most important is that you realise ... There is no spoon.
I wouldn't call it an issue. More a design consideration, console does not coexist well with multibutton sets
Too much traffic for the card
**********************************************
What's most important is that you realise ... There is no spoon.
- Status
Similar threads
- Locked
- Question