Good day,
I recently bought a 2nd hard drive (IBM 120GXP 80Gb) to be installed as a slave to my Maxtor 80Gb Diamondmax. I connected all the cables as per specification, with the jumpers set correctly (Maxtor as primary, IBM as slave). Did the whole fdisk, partitioning and formatting, but every time Windwos 2K starts up, at the logon screen, it just reboots.... I then checked by booting up with Windows Me, but with Windows ME it works fine! The file system on both hard drives were formatted to be FAT32. I would appreciate any helpfull suggestions as I'm out of ideas!
Kind regards
Marius
I recently bought a 2nd hard drive (IBM 120GXP 80Gb) to be installed as a slave to my Maxtor 80Gb Diamondmax. I connected all the cables as per specification, with the jumpers set correctly (Maxtor as primary, IBM as slave). Did the whole fdisk, partitioning and formatting, but every time Windwos 2K starts up, at the logon screen, it just reboots.... I then checked by booting up with Windows Me, but with Windows ME it works fine! The file system on both hard drives were formatted to be FAT32. I would appreciate any helpfull suggestions as I'm out of ideas!
Kind regards
Marius