BigGuySmall
Technical User
Hello
Does anyone have any info on the commands to use to setup a secondary IP gateway under autoexec?
Last week my DSL gateway went down (back in business now) but I would like to have a failover situation such that if the primary gateway is down the smtp e-mail and internet access would just go to the secondary gateway.
I am using NW6 pure IP. I do not want to invoke inetcfg because I bind 4 NICs into a team and I need the freedom that autoexec supplies. My current command line is as follows (all on 1 line):
bind IP iANS Address=xxx.xxx.xxx.xxx Mask=xxx.xxx.xxx.xxx Gateway=xxx.xxx.xxx.xxx
Does anyone have any info on the commands to use to setup a secondary IP gateway under autoexec?
Last week my DSL gateway went down (back in business now) but I would like to have a failover situation such that if the primary gateway is down the smtp e-mail and internet access would just go to the secondary gateway.
I am using NW6 pure IP. I do not want to invoke inetcfg because I bind 4 NICs into a team and I need the freedom that autoexec supplies. My current command line is as follows (all on 1 line):
bind IP iANS Address=xxx.xxx.xxx.xxx Mask=xxx.xxx.xxx.xxx Gateway=xxx.xxx.xxx.xxx