2950 MultiVlan?

[dvbishop]

Can you configure a port on the 2950 for a mulivlan? For example can port 20 belong to both vlan 3 and vlan 4.

The 2950 was bought as the suggested replacment unit for a 3500. The 3500 has multivlan capability, but we have been unsuccessful in finding infomration on multivlans for the 2950.

 

[ianuk1974]

is this port going to be your uplink to another switch or is there going to be a phone connected then a pc connected to the phone?

Depending on your answer above depends on the config.

Switch to switch

2950(config-if)#interface fastethernet 0/20
2950(config-if)#switchport mode trunk
2950(config-if)#switchport tunrk allowed vlan 1,3-4, 1002-1005
2950(config-if)#no shutdown

Note 2950 switches only support 802.1q trunking so make sure your connecting switch is configured for dot1q.


Switchport to VOIP Phone

vlan 3 data
vlan 4 voice

2950(config-if)#interface fastethernet 0/20
2950(config-if)#switchport mode access
2950(config-if)#switchport access vlan 3
2950(config-if)#switchport access voice vlan 4
2950(config-if)#spanning-tree portfast
2950(config-if)#no shutdown

Hopefully this helps

 

[ADB100]

The multi-vlan feature of the 2900XL/3500XL is not available in any other platform as far as I know. Trunking is an alternative but your end device must support 802.1q trunking.

Good luck

Andy