Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

2621 multiple T1 clock config

Status
Not open for further replies.
mpjbell

mpjbell

IS-IT--Management
Nov 16, 2011
1
US
Hi guys,
New to the forum and new to cisco routing and configuration.

I currently have 2 cisco 2621's with 2 T1 Wics each i have am running WIC0 bridged over a private line from my data center to an off site rack space. This all works well and good. But i have been asked about clock setup. I currently have one side as line and the other as internal.

I have been asked to try and set the timing for WIC1 on one end to use WIC 0 on the same end as its clock. Is this possible or even neccesary or do I just set it to internal

Thanks, if you need more infore please just ask

Completey Lost

Mark
 
Status
Not open for further replies.

Similar threads

stanlyn
  • Locked
  • Question
HowTo Install Multiple PAP2T ATA Devices on Same Lan
Replies
3
Views
174
iggsterman
iggsterman
WinstonCH
  • Locked
  • Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat 1
Replies
1
Views
155
BIS
BIS
Drug_Store
  • Locked
  • Question
Cisco 3560g 48ports PoE - config
Replies
1
Views
80
Drug_Store
Drug_Store
evr72
  • Locked
  • Question
multiple devices multiple networks best practices help 1
Replies
1
Views
65
Speedline
Speedline
Sycho123321
  • Locked
  • Question
T1 wic configuration
Replies
0
Views
61
Sycho123321
Sycho123321

Part and Inventory Search

Sponsor

Back
Top