Currently have a 2620 doing data and pbx interface and dropping the pbx. There is a 2 channel T1 card, DSU/CSU card and a High Density Voice port adapter. What all do I need for only a point to point T1?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
2620 T1 Needs
- Thread starter techshoot
- Start date
Right, I'm not aware of any 2 channel T1 cards. The only "2 channel card" I'm aware of is a ISDN BRI wic (2 bearer channels and a data channel - 128k). Usually you're going to have a t1/frac t1 card or some flavor of isdn, either bri or pri(23 bearer channels w/ 1 data channel - 1.5Meg)
...i don't think pri is a option on the 2620.
Check your WIC module against the list @
good luck
...i don't think pri is a option on the 2620.
Check your WIC module against the list @
good luck
- Status
Similar threads
- Locked
- Question
- Locked
- Question