2600 Serial setup

[12122053]

We have a 2610 router with a T1 csu/dsu card which is connected through frame relay to our main office. We are only using 8 channels on the T1. I want to add a serial wic card for a RF controller. How will i configure the wic card to use the T1 csu/dsu bandwidth. The serial card needs to communciate to our main office. Could I setup certain channels for the WIC, thanks. Any configs will help.

 

[12122053]

All I want to do is let my new serial card use the csu/dsu bandwidth, does anybody have any suggestions ,thanks. We use frame relay.

 

[jeter]

Are you planning on using the same t1? ( 8 channels ) If so you are going to have too get say an adtran to break out the channels and reinstall to your cisco, via a serial int v.35 connection and a t1 wic. Jeter@LasVegas.com
J.Fisher CCNA

 

[12122053]

We are planning to upgrade our T1 to 16 channels Im assuming we willl still need the adtran. So you are saying if you have multiple serial interfaces you will need a adtran or similar device? Please explain, thanks jeter.