hello i recently put new flash mem into my 2521 router to upgrade.Now i have no usable interfaces and it boots to boot mode i.e frameswitch (boot)#. I'm using one of my routers as a tftp server.Is there a way for me to do this upgrade via the serial interface. The 2521 doesn't have ethernet just four serial ports a token ring/utp/bri. hopes this makes sense.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
2521 router upgrade
- Thread starter capefear
- Start date
Shouldn't be a problem. Make sure you can ping both routers before the upgrade across the serial interface.
Set the router (not being upgraded) to a tftp server using the TFTP-SERVER command and point it to the image you want to load on the 2500.
Follow the 2500 flash upgrade procedure (below) and point it to the IP address you previously assigned and tested to the other router.
Set the router (not being upgraded) to a tftp server using the TFTP-SERVER command and point it to the image you want to load on the 2500.
Follow the 2500 flash upgrade procedure (below) and point it to the IP address you previously assigned and tested to the other router.
- Status