Ok heres the problem. I wanted to upgrade the flash so i added more memory. I started the router and i got an error that the memory was reversed.
ERR: Invalid chip 0x80AB (reversed = 0x1D5 ) detected in System flash
So now i took the memory out and the router doesnnt respond at all to the console. When you reboot, it shows everything in the console all the way to what is pasted here
******
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(5), RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Thu 23-Mar-95 02:08 by kmac
Image text-base: 0x01020000, data-base: 0x00001000
cisco 2500 (68030) processor (revision A) with 4092K/2048K bytes of memory.
Processor board serial number 01x98465
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Authorized for Enterprise software set. (0x0)
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
Press RETURN to get started!
******
Now when i push return the router doesnt respond at all. And yes the connection to the console is working fine because i tested it out with another router and no problems.
Does anyone know what i could have done wrong? Is there any way to reset the router to manufactured defaults?
Any help is very much appreciated.
ERR: Invalid chip 0x80AB (reversed = 0x1D5 ) detected in System flash
So now i took the memory out and the router doesnnt respond at all to the console. When you reboot, it shows everything in the console all the way to what is pasted here
******
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(5), RELEASE SOFTWARE
(fc1)
Copyright (c) 1986-1995 by cisco Systems, Inc.
Compiled Thu 23-Mar-95 02:08 by kmac
Image text-base: 0x01020000, data-base: 0x00001000
cisco 2500 (68030) processor (revision A) with 4092K/2048K bytes of memory.
Processor board serial number 01x98465
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Authorized for Enterprise software set. (0x0)
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
32K bytes of non-volatile configuration memory.
Press RETURN to get started!
******
Now when i push return the router doesnt respond at all. And yes the connection to the console is working fine because i tested it out with another router and no problems.
Does anyone know what i could have done wrong? Is there any way to reset the router to manufactured defaults?
Any help is very much appreciated.