2500 switch Spaning Tree

[TDN2007]

Hi all,

i have a 2 questions,
What is the right CLI command to perform fast start-up for ports in the 2500 switch?, i tried the one used in both 470 and the 5500 it give invalid value
please need your help if any one know the right command because doing that for a 50 switch using JDM is a night mare.

the other question i want to make a backup copy of the configuration file for the 2500. what is the best practice to that?

Best Regards

 

[andy88]

Try,

spanning-tree port <port No> learning fast

 

[biv343]

For the fast start change:

interface fastethernet all
spanning-tree learning fast

To copy the config, have a TFTP server app running somewhere on a PC. Enter the following command:

copy config tftp address X.X.X.X filename config.cfg (or whatever you'd like to call the file).

 

[TDN2007]

thank you biv343 for this help.
but one last thing should i backup each switch a lone in a stack, or i can put all the stack in one config.cfg file ?!

and thank you all.

best regards.

 

[biv343]

If they are stacked, the config file of the stack is backed up in entirety in the one backup file.