2000IPS wireless

[3DNet]

Anyone had to re-issue LVP codes recently on the IPS? I had to order version 10.0 of Matworx IPS, log on to NEC's wireless site and get a wireless system ID. Then enter the system ID and authorize ZTs. After that, I had to re-download all the PSIIs--I don't remember having to re-download after re-issuing the LVP code.

The good new is apparently (or allegedly) the 2000 will no longer lose wireless after 8hrs without power.

Does anyone know if there is a plugin to Matworx IPS to program PSIIs since it's a PITA to build them in CAT mode? The old 3.6 version of Matworx had a nice plugin for that and I miss it very much after today.

 

[pave35]

You probably were using a different carrier pattern on the PS's. That is in CM AE15>00>0204060000 means you were using carrier pattern 2,4, and 6. If you used the addin in MATworx to authorize it will update the carrier pattern to 1,3,and 5 unless you change it on that screen. Since the PS's were previously scaning 2,4,and 6 they did not see anything until you re-downloaded them changing them to scan channels 1,3,and 5. I have see this happen many times.
The moral here is always check CM AE15>00 to see which control carrier pattern is being used before you hit the update button in the MATworx or you may end up with PS's giving "NO SERVICE". If you do change with MATworx accidently you can simply change back in MOC and depending on the PBX rev just reseat the CSIA cards to bring the ZT's on line with the new pattern.

 

[3DNet]

But is there a plugin to program PS data like in old MATWorX 3.6?

 

[pave35]

No.
The old Studio had some known issues with the PS programming portion. When it worked it was great. When it messed up it was dangerous.