2000 IVS(2) up (BUT) 1

[renosylvia]

I have the system up but no flashing in--or ringing in-on co Trunks.
When I do a power down or reset--co card starts flashing again. I have to assign trunks again in CMD10.
All programing in day 3002 and night 3003 ok. Also 3509-3520 and 3521 ok.
48 port software and co card located within this area.
System was previousy down because of AC power failure
Also when I loaded original backup disk--which ask for a reset after loading -- co card start flashing again
All co's light up and go off properly when the buttons are pushed. Bottom line no ringing??

THANKS again to all for your support.

 

[Fixin]

Be sure to do command EC6 before reset.

 

[dontworx]

I know it sounds crazy, but I would reload the software do b load and reload the backup. First you might want to call NTAC.

 

[dontworx]

By the way if you are using an IVS2 you don't have to do EC6. If you are using an IPS you have to do an EC6.

 

[OzzieGeorge]

It also sounds as though, when you do get this up and running, you need to string up the tech who didn't back it up to flash rom (assuming an IPS).

 

[mextera]

First in the thread you say that this is a IVS2 and the 48 port SW is loaded, heen you say all ports located in this area. Do you mean the first 6 LT slots? It must be in LT00 through LT 05.

Mextera,