2000 IPS CCIS to IPK

[TTPPI]

I am using CCIS over IP to connect a 2000 IPS to 2 IPK electra elites using point to multipoint CCIS. I do not have any audio across those trunks. Equipment is IPT card in 200 IPS and IAD cards in IPK's. SP2 on IAD and R12 on 2000. Any suggestions?

 

[LDthirtytwo]

Confirm the programming & switch settings are correct for the IPTB/4VCT cards, you have software in F88>05 for CCIS and 11 for IP CCIS, 4VCT cards are in the correct order 1>2>3>4 to the left or right of the pad card, that in F71 you have time slots for the lens? Have you tried swapping out hardware? All ports in the data switch/router that we connect to are set to 100MBPS/FDX, if spanning tree is turned on for the ports we connect to turn of Port Facilities and all patch cords are factory made and tested to cat 6 standards? If you still have problems sniff your network with Ether reel (Etherreal.com has a free sniffer)

 

[TTPPI]

All equipment is fine I have voice to another location that is an IPK. Sniffed with WIRESHARK (formerly ETHEREAL) and from source to destination the UDP packets appear to be leving and arriving ok, but I have an ICMP message that says Destination host unreachable (port unreachable) what is this ICMP used for? I see this message immediately after last digit is dialed and call is initiated. I can ping to all IAD from 2000 MP card. After original post I went back through all programming steps and it appears that CM 3591>XX>0-7 has NONE for that trunk route, so I believe the vendor who did the update did not apply the correct (or any) CCH for that trunk route to use. My other IPK route uses 0 can I make this one the same?

 

[ctvi]

see

http://www.2000stuff.com.

you nrrd 3591>rt>0 but check also their example. Here are some of their notes: They are using route 30 and note 3591 is related to 0607.
13. CM 3500>30>04
14. CM 3504>30>2
15. CM 3509>30>03
16. CM 3520>30>00
17. CM 3590>30>0
18. CM 3591>30>0

http://www.ctvi.com