Hello,
The setup: 4 locations vpned together(ipsec) in a mesh using watchguard devices(x700, soho6's).
1st: When I vpn remotely into the site with x700 via pptp, I can't vnc into one of the other locations directly, only that location that I'm vpned into. But if a vnc into that location then I can access the others. I see the firebox denying when I try to just vnc directly to one of the other locations. I know its a setting but don;t know where to start as I'm new to watchguard devices.
2nd: when at a PC inside the site with the x700, I can't connect via a pptp connection(just a windows xp one) to the outside. This is probably a rule that needs made in the firewall.
Any insight would be greatly appreciated. Thank you.
Jay
The setup: 4 locations vpned together(ipsec) in a mesh using watchguard devices(x700, soho6's).
1st: When I vpn remotely into the site with x700 via pptp, I can't vnc into one of the other locations directly, only that location that I'm vpned into. But if a vnc into that location then I can access the others. I see the firebox denying when I try to just vnc directly to one of the other locations. I know its a setting but don;t know where to start as I'm new to watchguard devices.
2nd: when at a PC inside the site with the x700, I can't connect via a pptp connection(just a windows xp one) to the outside. This is probably a rule that needs made in the firewall.
Any insight would be greatly appreciated. Thank you.
Jay