Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations derfloh on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

2 questions

Status
Not open for further replies.

jaylek

Technical User
Jul 29, 2002
139
OM
Hai,

Friends,I have two questions
1. Can the user change the extension password thru the phone?
2. My pstn is sending the full digitd for the DID. The number series is 2450000. I have created all the required extensions with the nutri cmd.
NUTRI: ENTRY=2450000,CNVTYP=0,NUMTYP=4,PRE=100;
MUTRI:ENTRY=24500500,CNVTYP=0,NUMTYP=4,PRE=500; like this I had created for all used extensions. But I have a problem with ext.(245). ext.105 is not initiated in the system and some one dials 24500105 it will ring on 245. How can we blocked the DID traffic for only the initiated extensions?
Thanks.
 
Hi

ASnwer 1 : Yes
Issue for Alex
"2.10 Changing individual authorization code
The individual authorization code can only be changed from your own telephone.

A specific procedure dialled from the extension must be used when changing a individual authorization code. The procedure is:

Dial * FC * previous authorization code * new authorization code #,
where FC is the function code for changing of individual authorization code.

Verification tone is received.
The authorization code will only be changed if the previous authorization code is valid. "

Answer 2 : It is a little bit difficult to udnertstand what's happening. In you NUTRI command some TRC parameter is missing, I guess that you are doing a TRC=7.
Could you post the NUTRP printout for line 24500245 and 24500105 ?
 
It's simple
You wrote, that you created NUTRI for all extensions. Because 105 is not extension, you have no NUTRI for this number and leading 245 is translated like extension number.

But your programming is very complicated. You can write only 1 line, where you clear public number.
NUTRI:ENTRY=public number,CNVTYP=0,NUMTYP=X,TRC=lenght of public number.
This line clear public number and you got only extension number. If you need more conversion, you can use parametr CONT and make conversion in extension's number range.
 
CFREI,
I got it from your point. I tested and is working fine. Thank you for the help.

Thanks fouesnant for your reply too.

cheers
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top