2 PRIs on BCM400 4.0

[Crowtalks]

I haven't installed a PRI on a BCM in 4 years and I haven't installed 2 PRIs in one ever, so I have a few quick questions.

I can't recall, where do you go to change the number of received digits for the target lines...is it in Dial Plan Public? (Telco sending me 7 digits and I changed it in Dial Plan-Public, but it still won't accept any more than 4 digits in the received number field of the target line)

The PRIs are independent of each with their own DID blocks. Would both PRIs be set as master?

I think I would use BlocA for one and BlocB for the other one...is that correct?

For 911 dialing...if I add 911 with absorb 0, then I can't add 91 for direct dial LD, what do I use to allow that in destination codes?

Sorry for all the questions...Jim

"If I had known it would turn out like this, I would have became a locksmith" Albert Einstein

NCSS NCTS NCTE CS1000E
Mitel 3300 4.2 basic & advanced, 5000 4.0, NuPoint I&M 4.2

 

[Crowtalks]

For the line that reads: For 911 dialing...if I add 911 with absorb 0, then I can't add 91 for direct dial LD, what do I use to allow that in destination codes?

I figured out Adding a 9A allowed the wildcard. With my second PRI, using 8 as external access, would it allow me to add 911 as a destination code here also?

thanks, Jim

"If I had known it would turn out like this, I would have became a locksmith" Albert Einstein

NCSS NCTS NCTE CS1000E
Mitel 3300 4.2 basic & advanced, 5000 4.0, NuPoint I&M 4.2

 

[Crowtalks]

Once again I found this info in my notes...The PRIs are independent of each with their own DID blocks. Would both PRIs be set as master?

There would be a Primary Reference instead of Master and only one Primary clock source on the system, so the other one would be Secondary Reference, similar to the Meridian systems.

"If I had known it would turn out like this, I would have became a locksmith" Albert Einstein

NCSS NCTS NCTE CS1000E
Mitel 3300 4.2 basic & advanced, 5000 4.0, NuPoint I&M 4.2