Hello I'm running a dhcp server with two IP addresses (different subnets) in one NIC. It connects to a 350 switch. There are two VLANs for that switch, say VLAN 1 and 2. Here is the VLAN table that I assigned:
VLAN 1: Port 1-5
VLAN 2: Port 5-10
So I plugged the DHCP server to port 5 and then assigned VLAN 1 and 2 to that port. Set Pvid to 1 and autoPvid enable. My machine on both VLANs can obtain the IP address and ping the DHCP server. However, after around 3-5 minutes later. The machines in VLAN 2 cannot contact the server. Is there anything i did wrong here? Any help would be much appreciated.
VLAN 1: Port 1-5
VLAN 2: Port 5-10
So I plugged the DHCP server to port 5 and then assigned VLAN 1 and 2 to that port. Set Pvid to 1 and autoPvid enable. My machine on both VLANs can obtain the IP address and ping the DHCP server. However, after around 3-5 minutes later. The machines in VLAN 2 cannot contact the server. Is there anything i did wrong here? Any help would be much appreciated.
