2 analogue phones with same telephone number 1

[atverre]

Is it possible to have 2 analogue positions with the same telephone number? How to?

 

[ArchibaldJCox]

You can either program two TNs to have the same DN assigned, or just bridge the cross-connects at the frame to split out the dialtone of one TN.

Arch


------

http://www.infoplusonline.com

 

[atverre]

When trying to program two analogue TNs with the same DN assigned I get the error message sch3300: The DN or Position ID is invalid, it must be unique.

 

[coniglio]

are you using the copy command? if so you will need a unique DN, then go back and change it to the correct DN.

 

[ArchibaldJCox]

If you split the cross-connects out then you won't have to use another TN. This could save you money on a maintenance contract with your vendor depending upon how they charge.




------

http://www.infoplusonline.com

 

[atverre]

Thanks Archibald and coniglio for your replies. I did use coniglios solution. I didn't know that it could be such an easy solution.

 

[dlesap]

- 1st solution is to program a second set with the same DN, but only one call at a time is possible.

- 2nd solution is to program the first set with CLS MCRA, and then program the 2nd one with the same DN and CLS MCRA also. When a call is coming the both sets will ring. After answering on one of it, the DN is avaliable for a 2nd call...

That's it.