LarrycAtOreilly
Technical User
I've got an old Prolient 1850R running NT4 and one of
the drives failed(RAID1-mirror). I swapped out the drive
and now I need to reset everything back to mirroring.
Using the NT4 Disk Admin tool, I was able to break the
mirror on the one remaining good drive.
However, re-establishing the mirror using Disk Admin did
not work.
I think this may need to be done at the hardware level,
before the OS loads. Are there any old-timers out there
that remember how go about this?
Thanks!
larryc
the drives failed(RAID1-mirror). I swapped out the drive
and now I need to reset everything back to mirroring.
Using the NT4 Disk Admin tool, I was able to break the
mirror on the one remaining good drive.
However, re-establishing the mirror using Disk Admin did
not work.
I think this may need to be done at the hardware level,
before the OS loads. Are there any old-timers out there
that remember how go about this?
Thanks!
larryc