1841 Router, and 3 or 4 bonded/MultiLink T1's

[beatdown]

We have an 1841 router, with two WIC-1DSU-T1-V2 cards. There are two data T1 lines, each plugging into one of the cards. The two T1's are bonded together in a multilink config.

We need more bandwidth, and have been offered an additional one or two T1's, basically for free.

Is there a way to add a 3rd or 4th T1 to the router, so they can be bonded with the other T1's?

I know with some older routers, you can buy a WIC card that has two serial link inputs per card, such as the WIC-2T...but I haven't seen any new 2 port cards, with the built in CSU/DSU, that'll do this in an 1800 series router.

Anyone know of a way to make this work?

 

[mahlad29]

It will work but first you need 1 or 2 of these cards VWIC2-2MFT-T1/E1 depending if you go 3 or 4 t1's
then you need to have the ISP set up there end.

http://www.cisco.com/en/US/products/ps5853/products_relevant_interfaces_and_modules.html

thats a list of cards available for the 1800 series routers

20 yrs old, working towards my CCNP. Looking for a new job
02472

 

[beatdown]

That's exactly what I need, thanks for your help!

 

[burtsbees]

You can have up to 6, but they MUST be the same ISP...

Also, they can be single WIC-1DSU-T1's if he wanted.

/

tim@tim-laptop ~ $ sudo apt-get install windows
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Couldn't find package windows...Thank Goodness!

 

[mahlad29]

^^ on an 1800?

20 yrs old, working towards my CCNP. Looking for a new job
02472

 

[burtsbees]

Uh, oh yeah...

/

tim@tim-laptop ~ $ sudo apt-get install windows
Reading package lists... Done
Building dependency tree
Reading state information... Done
E: Couldn't find package windows...Thank Goodness!