Fuzziedunlop
Programmer
Morning
I've an IP500 v2 running 8.0(44) with about 260 1608i handsets on a seperate stand alone network using Linksys poe switches and 1 non poe switch which they all connect to (acting like a master). All the handsets at anytime decide to reset on urq and come back up and work afterwards with no problem? The ip500 chassis has been changed and i've also swapped the SD Card. The network switches have no programming in them apart from a static ip address and default gateway (which is the ip500) the handsets are dhcp from the ip500 and will only dhcp to handsets, just in case anbody plugs into the network. The whole setup has been fine for a few months then this has started to happen? There seems to be a KeepAlive issue but as it doesn't happen all the time or any kind of pattern its hard to pin point. I've reset the poe switches as well. Any info would be great.
Cheers Fuzziedunlop
I've an IP500 v2 running 8.0(44) with about 260 1608i handsets on a seperate stand alone network using Linksys poe switches and 1 non poe switch which they all connect to (acting like a master). All the handsets at anytime decide to reset on urq and come back up and work afterwards with no problem? The ip500 chassis has been changed and i've also swapped the SD Card. The network switches have no programming in them apart from a static ip address and default gateway (which is the ip500) the handsets are dhcp from the ip500 and will only dhcp to handsets, just in case anbody plugs into the network. The whole setup has been fine for a few months then this has started to happen? There seems to be a KeepAlive issue but as it doesn't happen all the time or any kind of pattern its hard to pin point. I've reset the poe switches as well. Any info would be great.
Cheers Fuzziedunlop
