good day, made last week acquired an IP Phone 1608 model that brings the release ha1608ua1_22r16Bf.bin
configure the extension and ipo500 client device in the phone is configured values of the IP address, VLAN and IP address ipo500, when connected to the network, the phone apparently registered but after a few seconds, the phone goes off and returns to make his start, and so is cycled, only stays on when no network cable connected.
comparing the file with another phone 1608 that if it works well, this is the release ha1608ua1_2100.bin
Someone will know what is happening?
configure the extension and ipo500 client device in the phone is configured values of the IP address, VLAN and IP address ipo500, when connected to the network, the phone apparently registered but after a few seconds, the phone goes off and returns to make his start, and so is cycled, only stays on when no network cable connected.
comparing the file with another phone 1608 that if it works well, this is the release ha1608ua1_2100.bin
Someone will know what is happening?