1232 AND TVP50 LED BLINKING

[mdwaldner]

I HAVE TVP50 CONNECT TO A 1232PANASONIC SWITCH BOARD
BUT MY LED KEEPS FLASHING ON MY TVP50 WHEN I DO TROUBLESHOOTING IT TELLS ME NO PBX CONNECTION
THE INSTALLION MANUAL TALKS ABOUT 4WIRE CABLE WHY DO
WE NEED MORE THAN 2WIRE CABLE PER PORT

 

[cwc3]

one 2 wire jack on on b/y of jack on port one of tvp!

 

[telemarv]

2 pairs... 2 ports for digital integration. light is flashing because the integration is incorrect

 

[cwc3]

not true you only need the outside pins on port one to have
two voicemail ports on tvp 2b+d

 

[VinylDave]

not true! by programming the port to be a vm port it switches the inner pair to dpt or apt as the case may be, therefore giving 2 ports per slot.

dave

 

[Trotski]

I agree, Thats what the manual says

 

[telemarv]

You need both pairs on Jack 1 for 2 port digital integration

 

[cwc3]

all you need is one pair believe me on the black yellow!!
Believe me!!

 

[Phoneguy65]

1 pair only, just B&Y
The 2nd port is sent via the OHCA channel on the primary digital signal.

Feeding the analog port to the TVP50 won't hurt anything, but it's not going to serve any purpose other than waste a perfectly good analog port that could be used elsewhere.

ANALOG integration would use TWO analog ports and no digital ones, but on the TD1232, this would be terribly inefficient considering it fully supports DPITS connection.

Have fun.

Pat MacKinnon
Omni telecommunications Inc.,
London, Ontario, Canada
omnitel-ca

 

[cwc3]

Thanks for your input just like I said 2b+d comes off
of one pair!!