UncleRobert999
Technical User
Previously posted in the Cisco Routers forum, probably should have been here. I apologize, I'm new to the site!
I have a 1200 WAP and 1300 Bridge setup between 2 buildings, external antennas, no security or encryption (for de-bugging) and have the following problem:
Approximately every 20 minutes, the 1200 deauthenticates the 1300 and about a minute later, re-authenticates it. During this time, I lose my connection. I've been working with Cisco for the better part of 3 weeks without solving this. I have installed new firmware on both devices, I've replaced the 1300, tried every configuration I could think of for both units, etc.etc. One unusual indication is that the radio "Link Test" (1200 or 1300)will fail unless the packet size is set to "1", and it will pass every time with packet size set to 1.
I just can't understand why it would de-authenticate the radio association and not give a reason in the event log.
Has anybody out there had any thing like this? I can find no timer configuration whatsoever in the setup. Why 20 minutes? And the time between shutdowns is almost "to the second".
Thanks!
I have a 1200 WAP and 1300 Bridge setup between 2 buildings, external antennas, no security or encryption (for de-bugging) and have the following problem:
Approximately every 20 minutes, the 1200 deauthenticates the 1300 and about a minute later, re-authenticates it. During this time, I lose my connection. I've been working with Cisco for the better part of 3 weeks without solving this. I have installed new firmware on both devices, I've replaced the 1300, tried every configuration I could think of for both units, etc.etc. One unusual indication is that the radio "Link Test" (1200 or 1300)will fail unless the packet size is set to "1", and it will pass every time with packet size set to 1.
I just can't understand why it would de-authenticate the radio association and not give a reason in the event log.
Has anybody out there had any thing like this? I can find no timer configuration whatsoever in the setup. Why 20 minutes? And the time between shutdowns is almost "to the second".
Thanks!