12345432sadfsdfsfsd1
Instructor
Hi,
Why the minimum distance between 2 tranceiver in 10base5 network is 2.5m
Thanks
Why the minimum distance between 2 tranceiver in 10base5 network is 2.5m
Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations IamaSherpa on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
10base5
- Thread starter 12345432sadfsdfsfsd1
- Start date
- Status
10base5 better know as *thicknet*
Now I'm going to dig back aways here.. normally you would use something called a *vampire tap* where you will drill into the cable and install your tap. The cable had dots along it's length to tell you where you could drill and fill. If I had to guess, I would say the distance between them ( which was flexible.. you did not have to drill there) is based on a few things..
1: To keep a limit of taps per segment length? nomimally 500 meters with 100 taps
2: Issues of impedance?
3: Signal reflection issues and propagation delays?
Here is a good link with some details
MikeS Find me at
"The trouble with giving up civil rights is that you never get them back"
Now I'm going to dig back aways here.. normally you would use something called a *vampire tap* where you will drill into the cable and install your tap. The cable had dots along it's length to tell you where you could drill and fill. If I had to guess, I would say the distance between them ( which was flexible.. you did not have to drill there) is based on a few things..
1: To keep a limit of taps per segment length? nomimally 500 meters with 100 taps
2: Issues of impedance?
3: Signal reflection issues and propagation delays?
Here is a good link with some details
MikeS Find me at
"The trouble with giving up civil rights is that you never get them back"
- Status