Have a standard 0x32 with a PRI and a COMBO card. I’m getting the error for not enough receivers. My question is can I add a Services Card or do I have to upgrade to XC and use another Combo Card? It’s been so long I don’t remember if there are any issues running Service and Combo together.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations gkittelson on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
0x32 DTMF Receivers?
- Thread starter hawks
- Start date
Multimedium
Programmer
The Combination 6-port Cartridge contains 4 DTMF receivers. If you need more DTMF receivers, you have 3 options.
[ul]
[li]Add a Services Cartridge. It has 4 DTMF receivers. It will work with the current software.[/li]
[li]Add a Combination 6-port Cartridge. It also has 4 DTMF receivers. You will have to upgrade the software to XC.[/li]
[li]Add an E&M Trunk Cartridge. It has 2 DTMF receivers. The E&M Trunk Cartridge goes into a Trunk Module.[/li]
[/ul]
[ul]
[li]Add a Services Cartridge. It has 4 DTMF receivers. It will work with the current software.[/li]
[li]Add a Combination 6-port Cartridge. It also has 4 DTMF receivers. You will have to upgrade the software to XC.[/li]
[li]Add an E&M Trunk Cartridge. It has 2 DTMF receivers. The E&M Trunk Cartridge goes into a Trunk Module.[/li]
[/ul]
- Thread starter
- #3
I'll ditto that. You can use a services card with a combo card. Services in slot 1, combo in slot 2.
Brian Cox
Georgia Telephone
Brian Cox
Georgia Telephone
- Status
Similar threads
