Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chris Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

0MB written when looking at details

Status
Not open for further replies.
gsz11

gsz11

IS-IT--Management
Jun 20, 2001
82
US
Arcserve 2000
When I look at the details of the tape some of the times it shows that 0 mb have been written to them, even though the tape is full. Does anyone have any idea why this happens?
 
Status
Not open for further replies.

Similar threads

DrB0b
  • Locked
  • Question
Getting ready to go a new backup route, looking for opinions.
Replies
5
Views
147
DrB0b
DrB0b
Hackeber
  • Locked
  • Question
ARCServe Unloading Changer.nlm after it was sucessfully loaded. ( New at this )
Replies
0
Views
66
Hackeber
Hackeber
Kaps46
  • Locked
  • Question
Commvault- Data Aging stucks at 93%
Replies
0
Views
125
Kaps46
Kaps46
dekkar
  • Locked
  • Question
Backup Job starts at 2.5Gb/min but ends up at 1Gb/min
Replies
1
Views
82
dekkar
dekkar
techseek
  • Locked
  • Question
Explanation of Snapshot and when to use
Replies
0
Views
65
techseek
techseek

Part and Inventory Search

Sponsor

Back
Top