Hi
Any one had this problem before, have a 0549 on LED display, was using graphics card as main console but have been able configure a terminal to S1 and can now see the load information on this unit, other posts say it should ask you if you want to write the dump out or discard, then the syetm will carry on and load, but we don't seem to get this message, even though now i'm using the ascii terminal as the console.
Rebooted numerours times now and message not appearing.
This machine does not have a tape drive attached.
Any help greatly appreciated.
Bladesman
Certified Specialist pSeries AIX System Support.
Any one had this problem before, have a 0549 on LED display, was using graphics card as main console but have been able configure a terminal to S1 and can now see the load information on this unit, other posts say it should ask you if you want to write the dump out or discard, then the syetm will carry on and load, but we don't seem to get this message, even though now i'm using the ascii terminal as the console.
Rebooted numerours times now and message not appearing.
This machine does not have a tape drive attached.
Any help greatly appreciated.
Bladesman
Certified Specialist pSeries AIX System Support.