Search results for query: *

Just getting my feet wet with scsi but I can see something is wrong and was wondering if someone could help.When benching my old ide drive,I get 22mb/sec on read-write and the bench score for the scsi drive is 15.6mb/sec on read-write.Something is wrong here. Both drives=ntfs-xp 32bit pci...

I'm not an "ace" pc doctor but I've built a few pc's in my life and what I've found is this; The whirring sounds depend on a lot of things>manufacturer,vibration from the case,etc so thats not an issue.What IS an issue is the sounds when it first spins up,you dont want to here funny grinding...

I have both Atapi and SCSI drives(all have OS's)Is there a way to make multi-boot options for SCSI and Ide from the same boot choice window?The problem is,when I get to the boot choice window either one or the other has already loaded and the other HD will not show.

Any one who may come by this post and has problems with ANY device in a PC should not think twice and get a software prog called BUS HOUND.This is the quickest and most powerful utility I've ever used.You can control and repair anything in the pc with built in command codes,As you can see from...

I did try to format from my atto card but it just hangs.I DID get a dump out of the drive though,using express tools I got the following: Hex Dump of Mode Pages - - - Start of Data for Drive: - - - Drive #1 (0:0) DEC RZ2ED-LS (C) DEC0306 Current Pages: 81 0A E4 0C E8 00 00 00 05 00 FF FF...

I would also like to know;since the cheetah drive is being recognized as a DEC should I use ASPI or CAM?I have ASPI installed but not CAM.

I've been having difficulties installing an Atto dual chan SCSI adaptor.After going in the reg in Hardware>Device Map>SCSI,this is what I find: port0>bus0>initiatorid255>targetid0>logical initiator id0 all the info in here is for my IDE HardDrive. port1>bus0>initiatorid255>target id1>log...

Using WinXP,Atto dual chan adapter scsi II,Seagate cheetah scsi II 80pin,Icy Dock hot swap tray,adaptec LVD cable.When booting my seagate is being recogbized as a;DEC RZ2ED-LS(C).When I run my Atto tool in DOS I get the following error: Command Status:0X04 SCSI Error Occured SCSI Status:0X02...