Search results for query: *

The hint was great. I changed the clutch and the printer is working again. Thank you, Reinhard

I changed the clutch and the printer is working again. Thank you very much, Reinhard

Hi marty5261, I ordered a clutch today. Hopefully it will arrive tomorrow. I will inform you if the problem is solved. Thank you, Reinhard

Thank you marty5261. But what is the difference between duplex and single sided printing? I am able to print two sheets of paper and it doesn't matter if I print only onto one side or on two sides. Yesterday I got the same 07,005.47 error during the printer was ready to print. It didn't got a...

Hi, I have a huge problem with my Phaser 8200 and have checked everything I can think about. After printing two pages I get a 07,005.47 error. I checked everything I found in the forum. I cleaned the y-axis motor, checked if the pins of the maintenance kit are worn out and I disassembled the DM...

I have a problem with my Phaser 8200. If I try to print three pages or more, I get an error 07.005.47 after the second or third page. Then I can reboot the printer and print again two or three pages until the error is reported again. Sometimes the printer automatically reboots when it gets a...

Hello, sorry for answering so late. I was on vacation. The Xerox partnumer is: 150-0246-00 I used the instuctions on the following page to replace the bulbs: http://golfclubradar.com/xerox8200/ Reinhard

Thank you all, I replaced the bulbs two days ago and the printer works perfect again. But it was pretty difficult to get some replacement bulbs. Thanks, Reinhard

I have cleaned the drum temp sensor. That was not the problem. But I cannot see any light when I look into the vent. This really looks like that the bulbs are defect. Yesterday after two hours of warming up the drum had a temperature of nearly 60 degrees. So I think that the drum is heated by...

During warming up, the printer counts from 1% to 99%. Then it displays the warming up message without any %. Up to that the procedure is OK. But then it never gets warmed up. The message is shown for hours. Sometimes it automatically reboots itself. I turned the printer into the diagnosic mode...