Search results for query: *

non xerox ink.

It sounds as if you have bent the rail that the imaging unit slides into. I can not tell you how to remove the imaging unit other than seeing if the rail is bent and reforming it.

I would check the DM clutch. It is a spring wound clutch lubed with a yellow grease that becomes solid after a while. Clean and relube with a light grease.

PEST Error - Printhead Left jetstack disconnect. The left jetstack is not drawing the expected power from the supply. This error indicates a problem with the printhead. It will need to be replaced. A printhead is very expensive.

Are you using genuine Xerox ink? More than likely you need a ink loader assembly...

Is it possible the maintenance tray is blocking the paper feed path? with the right side guide broken and the part that holds the tray in missing, could the tray be sliding back into the paper path? Also how do the white milar strips look on the door?

The part you show is part of the right side guide. The Cap/wipe/purge comes down and hits this lever releaseing the maintenance tray.

Do you have access to service bulletin 580 rev 2?

Here is what the manual says:Accumulator belt out of position. 1. Is the imaging unit at the end of its life? 2. Is there toner on the accumulator belt cleaning blade holder? (The holder is located on the imaging unit, along the bottom of the green OPC belt.) 3. Check to see if any toner...

The 13,004.43 error is not a drum heater problem. The print head heater has went out... This heater is internal of the print head....

This is from the manual: The left jet stack heater is not heating at all, or is heating too slowly. Ensure the printer is not located next to an air-conditioning duct. Check that the printhead-to-drum gap is not too close (the drum can act as a heatsink). Inspect the printer wiring. Replace the...

You need to go into diags: 1. Turn the printer power On. 2. Wait for the Xerox logo to begin moving across the display. 3. Before the logo is centered on the display (stops moving), press and hold the Back and Help buttons on the Control Panel. 4. Hold both buttons until the display reads...

9,035.4x through 9, 038: Fault codes associated when ink count flags are stuck after melting 2.5 ink sticks. The following codes are recorded: 9,03x.41, where x= 5 for cyan, 6 for magenta, 7 for yellow, and 8 for black. Remove any blockage and/or replace the ink stick.Run clearISCfault test to...

The 19,004 error code is caused by the replacement printhead not being “zeroed-out” at the factory. In the mean time, if this happens again here is what you can do to get around it: 1. Turn off the printer. 2. Install a 2 mm 2-pin jumper on the top two pins of the Factory Only connector...

This is a process motor stall error. Verify process motor operation with the Process Motor diagnostic test. Also exercise processes run with the process motor; transfix, drum maintenance and head tilt. This can be caused by the power control board. The process motor may have more than one task...

No, the two use different engines.

Parts List 11.1 part no. 11:130E11750 Lever-Exit Sensor (Fuser Exit Sensor Actuator)This is from my Service Manual.

I got the no. from the service manual.

This is the no. I have: 130E11750

Accumulator belt cleaning blade movement error. If the Error 32 is constant: 1.Replace the imaging unit 2.Replace the accumulator cleaner clutch shaft and the cleaning board 3.Replace the engine control board. If the Error 32 is intermittent: 1.Replace the accumulator cleaner clutch shaft and...