Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Mike Lewis on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. GreginGraphics

    Message "You need to restart your computer." when copying files

    Thanks for more info Chiph, I emailed ATTO this morning and they already replied!! Here is what they had to say: "The ATTO PSC card is a single ended (SE) device and will need a terminator that is SE/LVD (low voltage differential). Most likely, the hard drives are LVD. The message you are...
  2. GreginGraphics

    "You need to restart your computer" error message OS X

    Hello, I made this thread to gather up information on this error message in OS X. The screen dims and message says: YOU NEED TO RESTART YOUR COMPUTER. HOLD DOWN THE POWER BUTTON FOR SEVERAL SECONDS OR PRESS THE RESTART BUTTON. underneath this is the message in serveral different languages...
  3. GreginGraphics

    Many problems on new G5 OSX

    I have a G4 and would have a lot of the same problems you have except I have a dual boot of os 9.2 and os X. It's too bad that you can't boot os 9 on a g5. That is the only reason I bought a g4 instead of a g5. Good Luck Greg
  4. GreginGraphics

    Message "You need to restart your computer." when copying files

    Thanks Chiph for the quote, Do I want to put the terminator at the very end of the cable or right after the last hard drive?? I think I will start a new thread about the error message: YOU NEED TO RESTART YOUR COMPUTER. HOLD DOWN THE POWER BUTTON FOR SEVERAL SECONDS OR PRESS THE RESTART...
  5. GreginGraphics

    Message "You need to restart your computer." when copying files

    OK, So I have to terminate both ends of the cable? With the Adaptec cable that I tested the RAID with some sucess it had a external LVD terminator that I put on the very end of the cable. The cable had SIX 68 pin connectors so two of the connectors was not used. Should I put the terminator on...
  6. GreginGraphics

    Message "You need to restart your computer." when copying files

    Hello, I am building a fast but cheap file server for only TWO clients with OS X 10.3.7 installed. The server is a G4 OS 10.3.7 450MHz 384MB RAM. - ATTO ExpressPCI PSC 68pin SCSI (came from a G3 300MHz, updated from apple firmware to ATTO's latest) - TWO Maxtor ATLAS 10K ver. II 18GB...

Part and Inventory Search

Back
Top