Search results for query: *

Thnks, I am all set on how to change it.

Try and check your MSEC prompt in the config record. should be off or no, I forgot which it wanted

Thnks curleycord. Sounds like a simple task but the docs only talk about changing the IP at startup and the step after making the change is to go to the install wizard. I have installed a few, just never had to change an active Mini and I know they can be a little touchy.Did I forget to mention...

Can the IP of a pilot mini be changed thru the web access with out reloading the database

Check the date field on the tnb and if it was changed you will at least know the last time a change was made on the TN

This setting is not for the D channel at all. It is a setting to state dd = maximum number of simultaneous voice or data calls 0-(24). I had to look back in an old release 4.5 doc to find this

Firebird Scrambler, thnks for the response, I have the 4 required packages and my d channel is configured like what you listed above. The voicemail is off the cisco,not call pilot. The problem above references rls 18, I am a cs1000e rls 7.65. ADAN DCH 21 CTYP TMDI MG_CARD 000 0 02...

I have a cs1000e rls 7.65 connected to a cisco call manager via qsig. Calls rout back and forth correctly. The customer wants to use the Office 365 voicemail off the Cisco for the CS1000 users. Preliminary testing has the calls forwarding to the voicemail pilot but it ends up getting answered...

I would bet that at one time this TN had a KEM and someone did a change to remove it and it should have been outed and rebuilt without the KEM programming. I would out it and rebuild it with the correct configuration.

It will work but probably not supported

Have you put a test set on the incoming trunk to make sure you have dialtone from the provider ?

Does anyone know what ports need to be opened on the data network for a TM rls 3.1 to administer an ITG card across a WAN

I understand that is the set up and commands for CDR but I was looking for the traffic reports

How do I send traffic info into the traffic buffer in ld 117 and then retrieve such info ?

is there a way to de-activate the sleep mode or adjust the timer to enter sleep mode ?

I recently installed a T7406e for a customer. The phone goes into sleep mode after 1 minute of idle time. The only way the customer has been able to get the phone out of sleep mode is to call it from another phone. Any ideas?

I would turn on d channel messaging in ld 96 and see what you are sending out. Sounds like a telco issue

This is a false alarm. Avaya has a patch for it. MPLR32701. I am not sure if it is public yet.

rlt and clt were not available until rls 25.40

I have upgraded a cs1000e to rls7.5 and left the MINI running with no problems. it interfaces thru the digital set port