Search results for query: *

Had a stack of six 3850-48p now need to move them to new location in two different places. Can not get 4,5&6 switch removed from the stack. Have tried no switch 6 provision ws-c3850-48p and I get error IDMAN can not find Board ID for switch 6.

It is working with 30 3560 & 3750 switch with just the command copy ru tftp

Having problem with 3850 when I TFTP startup-conf, file shows up on TFTP server but is empty. The following are the commands used: MTC-First_East-SW01#copy running-config startup-config Destination filename [startup-config]? Building configuration... Compressed configuration from 18232 bytes...

I found my problem bad fiber patch.

Has anyone setup trunk connection between a 3560 and 3850? I have a new 3850 and want to connect it to the network by a 3560 GI fiber port, cannot get link to connect, any help as to what I did wrong or will this not work for testing?

I understand there are many way to send calls to the attendent but somewhere that information is entered so the system know where to send incoming call from the carrier like AT&T. AT&T send the calls down a pri trunk and the system then send the calls to the attendent or if they are dids then...

Where is the setting for incoming calls to the attendent? I need to change the extention of the console.

Thanks for the information, I have it setup with ds1fd stations then added station to hut group, working great had problem with setup in server when lines were not working. Thanks again.

We need to send our dictation hunt group to a T1 installed in a server. Can someone give me a example this would be setup if it can be. We are running CM 5.2

Need to set up a backup 5520, we have one working and would like to have a backup if this one fails. Would like to hear the Pro's & Con's on how to set this up. Thanks

Thanks just what I was missing when looking

I need to see what station in the system have been transfered, can someone tell me the command to do this. Thanks

Have a 5520 with outside IP, we hand out ip to VPN users within our network range, they use our active directory for authentication. Problem is they can not get to servers on the inside vlans. If we connect to the inside vlan then can get to servers. Have static route to gateway on inside...

Thanks for all the information

Do you do anything on the port, or is this judt gobal settings.

I have a C3750 Software (C3750-IPBASE-M), Version 12.2(35)SE5 at my Avaya PBX and I need to add basic QOS on this switch, dose anyone have a example of this or where I can get basic QOS for dummies. What happen if I just use auto QOS on the switch?

Has anyone interface Castelle Faxpress to Avaya CM 5.2.1 to do print routeing of the faxes?

did not find anything listed there. I have a number 231-2700 that when it is called it ring at ext 285 in our system and I need to change that station number. Some where there is a table for this information.

CM 2 I think Old bell number that went to a standalone station

We are going to smart trunks Pri and have serval old Bell number that need to ring a one station. Can some one tell where this table information will be so I can start to input the information. Thanks