Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  • Users: rinma
  • Order by date
  1. rinma

    CLIP on ELU29

    Hi CPUX10, To get CLIP on analog.ext you need following: BC12 sp6 or higher, ELU 29, prom r10J licence for CLIP on analogue ext, and command: EXCAC:DIR=XXX,ICAT=0800; I have try it with trial licence and it works like charm. Tricky part is to get official licence becouse PocketSolveIT dont...
  2. rinma

    TD 500 PROBLEM

    Hi Damir, the service you need is called original A-number. In Croatia, original A-number only works with Vip-net GSM operator via direct-access service (tested with Ericsson MD110 PBX). T-com and T-mobile does not support this feature, yet. Bok Marin
  3. rinma

    access to WAP pages from DBC 4425

    thx Vendor71, I found and downloaded Now.WAP gateway with 30 days trial-licence, and got it working with out any problems! bye, rinma
  4. rinma

    access to WAP pages from DBC 4425

    Hi all, Has anybody tried to access WAP pages from DBC 4425? I have downloaded nokia WAP gateway simulator 4.0 and install it on PC - free one-user licence. In cfg. file of DBC425 I set up under WAP gateway IP address of PC where I installed Nokia WAP gateway, but when I try to access any wap...
  5. rinma

    Traffic recording for unanswered calls

    Great tip Mundus!! That is what I was looking for!! Thank you so much! And here is a star for you!
  6. rinma

    Traffic recording for unanswered calls

    Hi all, Is there a way to record in CIL output unanswered call to an extension? e.g. external number 2483-436 call extension 11002, ext. didnt answer the call, and CIL output shows that external number 2483-436 has called ext. 11002 and call duration was 0. System is BC11SP14 with SIU board...
  7. rinma

    IP networking ELU32

    Hi PCLOP, If a firmware version of ELU32 is R4F (from SP7), there is a published service advice for that firmware: Subject: New Service Advice for IP recommendations in BC12 systems has been released[Scanned] Hi All Jitter buffer configuration: In the SP7 package VOIPF R4F was released. It...
  8. rinma

    IP networking ELU32

    What is a SP of MD110? Which codec are you using? What is a firmware of ELU32 board? After restarting TLP65 is the error happend again?
  9. rinma

    Patch for LCR tone

    Hi MATOVTZ. I have same problem. Have you solve the problem? Did you perhaps aquire a patch since your post? Does anybody have a patch?
  10. rinma

    pelpi display info

    OK, when I try KSTSC:STRNO=IDL15,STRING=" "; "Profile" display info is gone, but it still remains info about number of Profile.
  11. rinma

    pelpi display info

    Thx hotload, this is one way to solve a problem, but is there a way to remove profile info from dbc212 display when telephone is in idle mode and still maintain pe function? Anybody??
  12. rinma

    pelpi display info

    Hi all, I have initiated pelpi function on bc12sp6, and it is working fine. On 212 DTS with pelpi function it is displayed active profile. My question: Is it possible to get back time and calendar info instead of profile info?
  13. rinma

    IP phone on same VLAN

    Hi all! I have 50 IP telephones (DBC 4422,DBC4425) on BC12sp5 (ELU32 R6A,fir.R3D) and I want to put them in one VLAN on cisco switch 2950. Any ideas?[ponder]
  14. rinma

    isdn bri dial backup for pppoe dialer

    Hi! Please help me! I have 1721 router with WIC ISDN bri card and 10 Mbit/s card.I have configured router for adsl connection with pppoe dialer and that works fine. Now, I have a problem how to configure ISDN backup link!!! Does anybody have any sample configurations??
    • rinma
    • Thread
    • Replies: 2
    • Forum: Cisco

Part and Inventory Search

Back
Top