Search results for query: *

Yeah the steps outlined do not work on XP (must have been a 2000 thing?). Anyone ever find a solution for this?

Thanks for the info!

I currently have numerous IP phones that connect over WANs to our option 11C. Users have complained that at times the voice quality is very poor. I would like to establish QOS over the WAN for the IP phones to maintain a better quality/service to the pbx. What protocol and ports do the IP phones...

Thanks guys, that was it. I had to add the new tenant route to the RLIs in LD86 and that allowed the tenant group to use the 9 to access the route.

I understand how to set up the Tenant-to-Route Access (RACC) and tenant-to-tenant Access (TACC), which is done in LD 93. Phones in the tenant group are able to access their route(access code 7004)by dialing the 7004 and then the outbound number they wish to call. What I would like to do is...

I have built a new tenant group that uses route 4 (Access code 7004). Whenever the tenant phones need to make an outside call they must first dial a 7004 to access their outbound trunks and then the number they wish to dial. I would like to change it so that when a phone in the tenant group...

I have an Option 11c that I am trying to create a new route on and trying to add analog GRD start trunks to this route. I have never created a route or a trunk before. This may be a very broad question, but, can anyone give a procedure or where to find information on how to create a route and...

I have an 11c that has two tenant groups already built on it that were setup by the installer. I would now like to add additional tenant groups. This is what I am trying to do to build an additional group: LD 93 REQ: New TYPE: TENS CUST: 0 It then gives me system message: SCH3921 Tenant service...