Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Search results for query: *

  1. tony11228

    Phaser 860- no mechanical initialization

    hi there.. Phaser 860 goes thru Post procedure, displays Xerox logo and green light is on steady. Just sits there indefinetly. It should start mechanical initialization but never does. No error codes. I tried to disconnect motors one at the time and powering up- no luck. Need help!!! Tony
  2. tony11228

    Phaser 860 does not cycle

    Yeah...of course. I checked thermistors on the board behind the halogen bulbs- they are not open. Problem is -no error codes, just sits there with xerox logo and ready light green.Help.....
  3. tony11228

    Phaser 860 does not cycle

    Hello there... I have a Phaser 860 that displayed error code 15.004.45.34775.Took it apart found bad bulbs inside preheat drum unit, replaced bulbs,reassembled it.Now, when the unit powers up,displays shows that it goes thru post procedure, displays xerox logo, ready light turns on green, and...
  4. tony11228

    Phaser 860N -need steps to replaced bulbs in drum heater

    Hi there! Where can I get instructions to properly disasemble and replace drum heater bulbs on my Phaser 860N? Thank you in advance.
  5. tony11228

    phaser 860 Display reads "Processing data- please wait".

    The message "Processing data- please wait" stays on very long time.Repowering does not help. Goes normally thru initializing,worming up,prints out out a "startup page"goes into warming up. The ready light never goes solid.Error code 15.004.45... came on about a month ago. After repower,unit...

Part and Inventory Search

Back
Top