Hi guys,
I just recently bought a 3Com AirConnect AP with WLAP feature. I don't really know about it, but it said about bridging between AP's with one AP as a Root AP. In the default setting WLAP mode is disabled, when I read the Ap manual it said to leave it disabled, because if the mode is...
to console into a router via aux port you have to set te line aux 0 to receive all kind of transport. And then telnet to one of your router's interface using port 200*
router#line aux 0
router(line)#transport all
router(line)#^Z
router#telnet (interface address) 2001
see for detail at cisco...
Hi guys,
My labs recently got an ANH 8 port router. Do you guys got any configuration examples on how connecting anh to a cisco router using frame-relay/x.25?
Thx :)
Insan_katob
HI guys,
I jeust crash out a cent100 via the what? prompt oops....damn..:(. When i entered my password, it fail and when i tried to debug it (again), start form 0fbc60000 appear this line:
BFC60000: 0000DCB3 DEAD1BAD 0005001F 0000125C
BFC60010: 007C0008 00000000 00010602 01010000
BFC60020...
I forgot something else. When i debugged start at 0fbc60000 there is a output looks like these..
BFC60000: 0000DCB3 DEAD1BAD 0005001F 0000125C
BFC60010: 007C0008 00000000 00010602 01010000
BFC60020: 14041000 00000000 000B0923 00023000
BFC60030: 46204000 00FFFF00 000000FF 00000000
BFC60040...
Hi guys..
I just crash-out a centillion via what prompt, now I lost my configuration without backups, and I'm completely lost.
Anyway to revert to factory default?
Thanks
Insan_katob
try this site--> ftp://ftp-support.baynetworks.com/pubswcode/centillion/c100/
to look for new image. Before that, try to disconnect RAM for a few minutes. Then Reset.
Password Recovery
1. If using an AN, power it off, then open it and put a jumper on pin S16, behind the power LED. If using an ANH-8, power it off and put a jumper on pin J7.
2. Power ON the AN. The unit completes the boot cycle in diagnostic mode.
3. At the prompt, type rb c00000 10. A...
Hi,
I've downloaded SpeedView and C100 image. The image has extension *.100 right? when I install speedView in typical Setup, It ask for the image file. When I select the path where the image file was and continue, the setup says that there is no image file/disk. Is it me or I also had to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.