Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
-
NetBIOS blocking on T1s?
Pixboy, You can apply the access list in both directions: int ser 3/0.1 access-group 101 in access-group 101 out int ser 3/1.1 access-group 101 in access-group 101 out Or you could apply the "in" on the other interfaces on the router (fa 0/0, etc). Are you running cef? You want... -
NetBIOS blocking on T1s?
The access list looks good. It would be applied to the sub-interfaces and the same access-list would be applied using the "access-group 100 in/out" int ser 3/0.1 access-group 101 in int ser 3/1.1 access-group 101 in The in ou out depends where the servers you are trying to protect... -
Problem connecting to Internet, please help
What address are the internal devices using as the default gateway. Were they using the ip address of the firebox? If they were, then they can't find the default gateway. Change one of you devices to use the 2611 Fa 0/0 (192.168.1.1) as the default gateway and see if it can't get to the... -
Bridging with Cisco 2600s and serial interfaces
What kind of serial cables are you using? Attached to one router needs to be a DCE cable while the other needs to be a DTE Cable. On the router using the DCE cable you need to configure a clock rate 1300000 (to emulate a T1). Once this is set up then the clocking should work and the circuit... -
QoS on 12000 Series Routers (GSR)
I am looking for some pratical examples of configuring QoS (MDDR/WRED/RED) on a GSR. I have looked on CCO and understand the technology. I know that each Engine type handles QoS differently. I would like to see configuration examples for Engines 0, 1, & 2. Paul Hoyle, CCNP/CCAI
