Search results for query: *

Hi acewarlock, I changed but no impact. Actually there shouldn't be any impact because this is another CLID entry (properly configured:). So If I don't see the previous one I will not see another one as well.

Yes, I did enl msgo x on the d in 96 and then I could see CAUSE: #21 - CALL REJECTED. I agree that pri can reject the call and send that as well. But probably it would't be dch message. In my oppinion ncos, targ has nothing to do with dch message exchange. If targ, cos don't match you will never...

Hi john poole, Definitely this is not caused by ncos or the cdb opt to cff. Besides the message CAUSE: #21 - CALL REJECTED has been sending by the provider's exchange, not by my trunk or system in general I asked today my provider not to ignore my calls without unknown originating number (or...

Hi john poole, Call forward within my system works, it's not blocked by ncos, trunk, etc. The call is leaving my system and rejection is coming from PRI provider because it doesn't see originating number. The situation is following: incoming call ---> COT ----> 2008 (nbr 225942112) ---->PRI...

Here it is: TN 006 0 00 00 TYPE COT CDEN 8D CUST 0 XTRK XCOT FWTM NO BIMP 3COM TRK ANLG NCOS 0 RTMB 2 1 NITE 2112 SIGL LOP SUPN YES STYP BTS AST NO IAPG 0 SEIZ NO PPID 0 BTID 0 S UNR DTN WTA LPR APN THFD BARD P10 LOL TKID 8460101 DATE 13 MAY 2007 DES OFFICE TN 007 0 00 10 TYPE...

Hi All, I have following problem: A COT analogue copper line is terminated on 2008 telephone (through ATDN on COT). A 2008 has an active call forward and should redirect the call over PRI trunk, but it fails. But when I call that 2008 over PRI trunk, redirection is working fine A 2008 has its...

Problem has been solved. Remains of tenant experiments, LD15, Net_Data, BSGC was 0 instead 1 or any other value than 0. Thank's ArchTelecom and techman3030 for interest Regards Pawel

I have 3820 & 3310 phones and problem concerns all of them

I have already done this and no change. PBX was reloaded for any case and ofcourse no change.

Hi, Unfortunately no change. This transfer was working fine some time ago (even last week) In the meantime I made some configuration regarding tenant service. When I noticed problems with this transfer I removed all tenant configuration but it changed nothing

Hello everyone I have Meridian 1 Opt.11, s/w rel.23. My problems is following: 1. I answer external call 2. I'm pressing Transfer key and dialing internal DN, pressing Transfer key second time to transfer the call and nothing happens. This problem concerns all my phones. When I answer...

Sure I am not going to hang up callers I was just looking for simpler solution than FNA. Anyway thanks for help. Pawel

And is there any direct way to configure it using only specific timer value or number of rings, without FNA ? I'd like to do it as easiest as possible. regards, Pawel

Hello, How should I configure specific TN to disconnect incoming external and internal call which is no answered after about 30 sec ? My system is Meridian 1 opt. 11 , sw. rel. 23 regards, Pawel