Search results for query: *

There is one brass bushing that goes into the left side of the chassis and must be oriented to fit totaly in the hole. I made sure that one was right. There is only one like that to worry about right? In diagnostic mode, I ran the test that turns the feed rollers and it turned just fine. On the...

By the way, all clutches and paper sensors at the preheater entrance are working.

Next here is what I've learned. I now know how to run diagnostics. In the Field Service Menu, I ran.. I think it was Check Paper Path and I selected "All Tests" It ran through quite a few things then Failed Check Cap Alignment. It displayed: Check Cap Alignment Measuring Left Belt Hysteresis...

I also see that I have the same symptoms as "Printflight" 3 Threads down on the main forum page. I checked my sensors and they seem to be there and move freely.

Thanks for the sugestion Marty but it's very tight. It's so tight that when I took out the assy the wires are attached to that I couldn't get it apart so I left it together and gently dangled the assy by the wires. Nothing looks pulled out or stressed. I figuredout how to get into diagnostic...

Hi, Hope somone can help. I just replaced my heater lamps in my 8200 and they heat up just fine. I pass all post tests and when it tries to print it's test page, my paper jams. It jams just above the maintenance tray as it tries to enter the rollers just above the tray. With my side covers off...